Users Guide


Port Settings

Purpose:

To specify whether to enable or disable printing ports and management protocol features.

Values:


TCP/IP

Purpose:

To configure the IP address, subnet mask, and gateway address of the printer.

Values:

Administrator E-Mail
Address
Specifies the contact address of the printer administrator and service center up to 63 alphanumeric characters.
Asset Tag Number
Enter the asset tag number for the printer.
EWS Settings
Auto Refresh
On
Refreshes the contents of the status display pages automatically.
Off
Does not refresh the status display pages automatically.
Auto Refresh Interval
Sets the time interval for refreshing the contents of the status display pages automatically from 15 to 600
seconds.
NOTE: The auto refresh feature is effective for the contents of the Top Frame, Printer Status page, Job List page, and Completed Jobs page.
Ethernet
Ethernet
Settings
Auto
Detects Ethernet transmission rate and the duplex settings automatically.
10Base-T
Half-Duplex
Selects 10Base-T Half-Duplex as the default value.
10Base-T
Full-Duplex
Selects 10Base-T Full-Duplex as the default value.
100Base-TX Half-
Duplex
Selects 100Base-TX Half-Duplex as the default value.
100Base-TX Full-
Duplex
Selects 100Base-TX Full-Duplex as the default value.
Current Ethernet Settings
Displays the current settings of Ethernet.
MAC Address
Displays the printer's MAC address.
Port
Status
LPD
Select the check box to enable the LPD.
Port9100
Select the check box to enable the Port9100.
FTP
Select the check box to enable the FTP port.
E-Mail Alert
Select the check box to enable the E-Mail Alert feature.
SNMP Agent
Select the check box to enable the SNMP (Simple Network Management Protocol).
You can also configure the transport protocol to be used. UDP can be selected as the transport
protocol.
NOTE: The settings in the Port Settings page will be valid only when the printer is rebooted. When you change or configure the settings, click the
Restart printer to apply new settings button to apply new settings.
TCP/IP
Settings
Host Name
Specifies the host name up to 47 alphanumeric characters. The default name will remain valid if no entry is made.
IP Address
Mode
AutoIP
Automatically sets the IP address.
DHCP
Uses DHCP to set the IP address.
BOOTP
Uses BOOTP (BOOTstrap Protocol) to set the IP address.