Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tool
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antenna
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Loosen the thumbscrew (#6-32) that secures the side cover to the computer.
2. Slide the side cover towards the front of the computer and remove the side cover from the computer.
Installing the side cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the side cover and provides a visual representation of the installation procedure.
Removing and installing components
15