Service Manual
Table Of Contents
- Precision 3260 Compact Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tool
- Screw list
- Major components of Precision 3260 Compact
- Side cover
- 2.5-inch hard drive
- Riser card
- Wireless card
- Speaker
- Processor fan
- Memory module
- M.2 solid-state drive
- Removing the M.2 2230 PCIe solid-state drive (slot-1)
- Installing the M.2 2230 PCIe solid-state drive (slot-1)
- Removing the M.2 2280 PCIe solid-state drive (slot-1)
- Installing the M.2 2280 PCIe solid-state drive (slot-1)
- Removing the M.2 2230 PCIe solid-state drive (slot-0)
- Installing the M.2 2230 PCIe solid-state drive (slot-0)
- Removing the M.2 2280 PCIe solid-state drive (slot-0)
- Installing the M.2 2280 PCIe solid-state drive (slot-0)
- Expansion card
- Optional I/O module
- Coin-cell battery
- Heat sink
- SATA FFC module
- Processor
- System board
- Internal antenna
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Getting help and contacting Dell
About this task
The following image(s) provides a visual representation of the 2.5-inch hard-drive caddy removal procedure.
Steps
1. Pry the hard-drive caddy to release the tabs on the caddy from the slots on the 2.5-inch hard drive.
2. Lift the 2.5-inch hard drive off the hard-drive caddy.
Installing the 2.5-inch hard-drive caddy
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image(s) provide a visual representation of the 2.5-inch hard-drive caddy installation procedure.
Removing and installing components
19