Service Manual
Table Of Contents
- Precision 3460 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3460 Small Form Factor
- Side cover
- Front bezel
- Hard drive
- Hard-drive and optical-drive bracket
- M.2 solid-state drive
- Removing the M.2 2230 solid-state drive (slot-1)
- Installing the M.2 2230 solid-state drive (slot-1)
- Removing the M.2 2230 solid-state drive (slot-2)
- Installing the M.2 2230 solid-state drive (slot-2)
- Removing the M.2 2280 solid-state drive (slot-1)
- Installing the M.2 2280 solid-state drive (slot-1)
- Removing the M.2 2280 solid-state drive (slot-3)
- Installing the M.2 2280 solid-state drive (slot-3)
- WLAN card
- WLAN antenna
- Coin-cell battery
- Memory
- Hard-drive and optical-drive supporting bracket
- Expansion card
- Optical drive
- Speakers
- Processor fan and heat-sink assembly
- Processor
- Power-supply unit
- Fan
- Power button
- Intrusion switch
- SD-card reader
- Optional I/O modules (PS2/Serial)
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Align the notch on the memory with the tab on the memory-module slot.
2. Slide the memory firmly into the slot and press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
3. Close the memory module door and press down firmly till it clicks in place.
Next steps
1. Install the hard-drive and optical-drive cage.
2. Install the 3.5-inch hard-drive.
3. Install the 2.5-inch hard-drive.
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in after working inside your computer.
Hard-drive and optical-drive supporting bracket
Removing the Bay support bracket
Prerequisites
1. Follow the procedure in before working inside your computer.
Removing and installing components
41