User manual

142 Understanding the Printer Menus
Va lu e s:
NOTE: This item is only available for LPD or Port9100 .
Initialize NVM
Purpose:
To initialize network data stored in NVM (non-volatile memory). After executing this function and rebooting the
printer, all network settings are reset to their default values.
Va lu e s:
PS Data Format
Purpose:
To specify the PostScript 3 Compatible communication protocol. You can configure the PS Data Format settings for
the wired network.
Va lu e s:
Wi-Fi
Purpose:
To enable the wireless connection.
Va lu e s:
NOTE: This item is available only when the Ethernet cable is disconnected.
NOTE: When you use the USB connection and do not use the wireless connection, you need to disable the wireless LAN.
Fax Settings
Use this menu to configure the basic fax settings.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
No. n/Address
(n is 1-5.)
Sets the IP address for Filter
n .
No. n/Mask
(n is 1-5.)
Sets the address mask for Filter
n .
No. n/Mode
(n is 1-5.)
Reject Rejects an access from the specified IP address.
Accept Accepts an access from the specified IP address.
Off* Disables the feature for Filter
n .
Yes Initializes network data stored in NVM.
No* Does not initialize network data stored in NVM.
Auto* Sets the PostScript 3 Compatible communications protocol automatically.
Standard Sets the PostScript 3 Compatible communications protocol to Standard.
BCP Sets the PostScript 3 Compatible communications protocol to BCP.
TBCP Sets the PostScript 3 Compatible communications protocol to TBCP.
Off Disables the wireless connection.
On* Enables the wireless connection.