User Manual
Table Of Contents
- WARNING: Use of controls, adjustments, or procedures other than those specified in this documentati
- Dell Display Manager User's Guide
- Overview
- Using the Quick Settings Dialog
- About Your Monitor
- Setting Up the Monitor
- Operating the Monitor
- Troubleshooting
- Appendix
- Setting Up Your Monitor
- Overview
44 Operating the Monitor
When the monitor enters the Power Save mode, the following message
appears:
Entering Power Save Mode.
Dell E1715S
Activate the computer and wake up the monitor to gain access to the
OSD.
If you press any button other than the power button, the following
messages will appear depending on the selected input:
Dell E1715S
There is no signal coming from your computer. Press any key on the
keyboard or move the mouse to wake it up. If there is no display,
press the monitor button now to select the correct input source on
the On-Screen-Display menu.
If VGA or DP cable is not connected, a floating dialog box as shown below
appears. The monitor will enter Power Save Mode after 5 minutes if left at
this state.
No VGA Cable
Dell E1715S
The display will go into Power Save Mode in 5 minutes
www.dell.com/support/monitors
Dell E1715S
No VGA Cable
See Solving Problems for more information.