Installation Guide

2. Insert the mounting brackets onto the mushroom head on each side of the switch and slide the mounting bracket back to
lock it into place.
The mounting bracket ears face the I/O-side of the switch.
3. Attach the mounting brackets to the switch using four screws for each bracket.
4. Slide the switch into the two-post rack until the mounting bracket ears line up with the rack.
5. Attach the switch to the two-post rack using two #12-24 screws on each side.
To uninstall the switch from the rack, unscrew the four #12-24 rackmount screws and slide the switch from the rack.
Wall- or ceiling-mount switch installation
This installation procedure is for the full-width N3200-ON Series switches only.
NOTE: Do not use this installation procedure to wall- or ceiling-mount the compact N3208PX-ON switch.
NOTE: For the N3224PX-ON, N3248P-ON, and N3248PXE-ON switches, to install an external power supply, see the
External Power Supply (EPS) Installation for the Dell EMC PowerSwitch N2200-ON and N3200-ON Series Switches at
www.dell.com/support.
You must order the mounting supplies for this installation separately. You need a drill and a pencil to complete this procedure.
1. Remove the four wall- or ceiling-mount brackets, wall anchors, and screws.
2. Screw two brackets to the left side of the switch using two screws for each bracket.
Torque the screws to 10 in-lbs.
N3200-ON Series switch installation
33