Installation Guide
Table Of Contents
- Dell EMC PowerSwitch N3200-ON Series Installation Guide
- About this guide
- N3200-ON Series switch
- Site preparations
- N3200-ON Series switch installation
- Unpack
- Rack or cabinet hardware installation
- Ground cable
- Desktop
- N3208PX-ON ceiling-mount switch installation
- N3208PX-ON wall-mount switch installation
- Standard bracket two-post installation
- Two-post five-inch-offset switch installation
- Two-post flush-mount switch installation
- Wall- or ceiling-mount switch installation
- One RU ReadyRails installation
- Optics installation
- Switch start-up
- After switch placement
- Switch replacement
- External power adapter
- Power adapter holder assembly
- Wall or ceiling installation
- DIN rail installation
- Single-EPA and switch four-post installation
- Single-EPA and switch two-post center-mount installation
- Single-EPA and switch two-post front-mount installation
- Dual-EPAs two-post front-mount installation
- Dual-EPAs two-post center-mount installation
- Power supply
- Fans
- Management ports
- Installation using ONIE
- Specifications
- Dell EMC support
Dual-EPAs two-post front-mount installation
To install two EPA power adapter holders in a front-mount two-post rack:
NOTE: This installation instruction procedure applies to the N3208PX-ON switch only.
NOTE: For this installation, you need two-rack units of space in your mounting rack. Install the switch in the bottom portion
of the two-rack units and keep the top portion open.
1. Align the mushroom heads on one power adapter holder with the two cutouts on the second power adapter holder and slide
together.
2. Secure the two power adapter holders together with four screws—two at the front and two at the back of the assembly.
3. Install the two EPAs in your power adapter assembly and secure with metal straps and screws.
For EPA installation instructions, see Power adapter holder assembly.
4. Align the right L-bracket with the mushroom heads on the right side of the assembly.
Face the L-bracket flange towards the front of the assembly.
5. Secure the left L-bracket with four screws.
50
External power adapter