Troubleshooting guide

printer. Enter 3 if your printer shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum warm-up time. Select a
value between 1 and 30 minutes for power save mode if you want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives data from the computer. You can also return the printer to
the standby mode by pressing any button on the operator panel.

Audio Tones
Purpose:
To configure settings for tones emitted by the printer during operation or when a warning message appears.
Values:

Fault Time-Out
Purpose:
Specifies in seconds the amount of time the printer should cancel for a job stops abnormally. The print job is cancelled if the time-out time is exceeded.
Values:

Time-Out
Purpose:
To specify in seconds the amount of time the printer should wait for data to arrive from the computer. The print job is cancelled if the time-out time is
exceeded.
Values:

Panel Language
Purpose:
To determine the language of the text on the operator panel screen.
Control Panel
Off*
Does not emit a tone when the operator panel input is correct.
On
Emits a tone when the operator panel input is correct.
Invalid Key
Off*
Does not emit a tone when the operator panel input is incorrect.
On
Emits a tone when the operator panel input is incorrect.
Machine Ready
Off*
Does not emit a tone when the printer becomes ready.
On
Emits a tone when the printer becomes ready.
Job Completed
Off*
Does not emit a tone when a job is complete.
On
Emits a tone when a job is complete.
Fault Tone
Off*
Does not emit a tone when a job ends abnormally.
On
Emits a tone when a job ends abnormally.
Alert Tone
Off*
Does not emit a tone when a problem occurs.
On
Emits a tone when a problem occurs.
Out of Paper
Off*
Does not emit a tone when the printer runs out of paper.
On
Emits a tone when the printer runs out of paper.
Low Toner Alert
Off*
Does not emit a tone when toner or some other consumable is low.
On
Emits a tone when toner or some other consumable is low.
Base Tone
Off*
Does not emit a tone when the operator panel display is returned to the default settings by scrolling the loop menu.
On
Emits a tone when the operator panel display is returned to the default settings by scrolling the loop menu.
60 sec.*
Specifies in seconds the amount of time the printer cancels for a job stops abnormally.
3-300 sec.
Off
Disables the fault timeout.
30 sec.*
Specifies the amount of time the printer should wait for data to arrive from the computer.
5-300 sec.
Off
Disables the job timeout.
Downloaded from ManualsPrinter.com Manuals