User's Manual

Back to Contents Page
 Faxing
FAX Country Setting
Setting the Printer ID
Using the Number Keypad to Enter Characters
Setting the Time and Date
Changing the Clock Mode
Setting Sounds
Specifying the Fax Settings
Sending a Fax
Sending a Delayed Fax
Sending a Fax from the Driver (Direct Fax)
Receiving a Fax
Automatic Dialing
Other Ways to Fax
Printing a Report
Changing Setting Options
FAX Country Setting
The FAX country setting is used to set the country where your printer is used. This is a requirement for using the FAX service on the printer.
There are two ways to set the country settings:
l Fax Initial Setup - a part of the installation software
l Printer operator panel - follow "FAX Country Setting Procedure"
You will have to use the operator panel and follow the instructions below, if:
l You purchased your printer with a new Dell computer
l You have finished Windows Installer setup without completing FAX Initial Setup
l You wish to change the country settings of where your printer is used

FAX Country Setting Procedure

To set the country settings from the printer operator panel:

1. Press until >SETUP appears, and then press .

2. Press until >Admin Menu appears, and then press .

3. Press until >Fax Settings appears, and then press .

4. Press until >Country appears, and then press .

5. Select the country where the printer is used.
The printer must be rebooted after you set the country settings. When a message prompting you to reboot the printer appears, select Yes. After the reboot,
the top menu is displayed on the operator panel.

6. Press until >SETUP appears, and then press .

7. Press until >Admin Menu appears, and then press .

8. Press until >System Settings appears, and then press .

9. Press until >Clock Settings appears, and then press .
