User's Manual


5. >Set Date is displayed. Press .

6. Enter the correct date using the number keypad.

7. Press when the date on the display is correct.

8. Press until >Set Time appears, and then press .

9. Enter the correct time using the number keypad.

10. Press when the time on the display is correct.

11. Press to return to the standby mode.
Changing the Clock Mode
You can set the current time using either the 12-hour or the 24-hour format.

1. Press until >SETUP appears, and then press .

2. Press until >Admin Menu appears, and then press .

3. Press until >System Settings appears, and then press .

4. Press until >Clock Settings appears, and then press .

5. Press until >Time Format appears, and then press .

6. Press until the desired format appears, and then press .

7. Press to return to the standby mode.
Setting Sounds

Speaker Volume

1. Press until >SETUP appears, and then press .

2. Press until >Admin Menu appears, and then press .

3. Press until >Fax Settings appears, and then press .

4. Press until >Line Monitor appears, and then press .

5. Press until the desired volume appears, and then press .

6. Reboot the printer by turning the power switch off and then on again.

Ringer Volume
NOTE: If you make a mistake while entering numbers, press to reenter the digit.
NOTE: The printer beeps and does not allow you to proceed to the next step if a wrong number is entered.
NOTE: The following settings can be configured also using Fax Initial Setup on the Windows Installer.