User's Manual


Line Type
Purpose:
To select the default line type.
Values:

Tone/Pulse
Purpose:
To select the dialing type.
Values:

Resend Delay
Purpose:
To specify the interval between resend attempts within the range of 3 to 255 seconds. The default is 8 seconds.

Redial Attempts
Purpose:
To specify the number of redial attempts to make when the destination fax number is busy, within the range of 0 to 13. If you enter 0, the printer will not
redial. The default is 3.

Redial Delay
Purpose:
To specify the interval between redial attempts within the range of 1 to 15 minutes. The default is 1 minute.

Junk Fax Setup
Purpose:
To reject unwanted faxes by accepting faxes only from the fax numbers registered in the Phone Book.

Remote Receive
Purpose:
To receive a fax by pressing a remote receive code on the external telephone after picking up the handset of the telephone.
Values:
Low
Sets the volume of the ring tone to Low.
Medium
Sets the volume of the ring tone to Medium.
PSTN*
Uses PSTN.
PBX
Uses PBX.
Tone*
Uses tone dialing.
Pulse (10PPS)
Sets "DP (10PPS)" (Dial Pulse, 10 Pulse Per Second) as the dial type.
Pulse (20PPS)
Sets "DP (20PPS)" (Dial Pulse, 20 Pulse Per Second) as the dial type.
Off*
Does not reject faxes sent from unwanted numbers.
On
Rejects faxes sent from unwanted numbers.
Off*
Does not receive a fax by pressing a remote receive code on the external telephone.
On
Receives a fax by pressing a remote receive code on the external telephone.