User's Manual

Values:

Fax Transmit
Purpose:
To set whether to print a transmission result after a fax transmission.
Values:

Fax Broadcast
Purpose:
To set whether to print a transmission result after a fax transmission to multiple destinations.
Values:

Fax Protocol
Purpose:
To set whether to print the protocol monitor report, which helps you identify the cause of a communication problem.
Values:

System Settings
Use System Settings to configure the printer's power saving mode, warning tones, time-out duration, device display language, and job log auto print settings.

Power Saver Timer
Purpose:
To specify the time for transition to power saver mode.
Values:
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less energy, but requires more warm-up time for the printer.
Enter 5 if your printer shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum warm-up time. Select a
value between 5 and 60 minutes for power save mode if you want a balance between energy consumption and a shorter warm-up period.
Auto Print*
Automatically prints a fax activity report after every 50 incoming and outgoing fax communications.
No Auto Print
Does not automatically print a fax activity report after every 50 incoming and outgoing fax communications.
Print Always
Prints a transmission report after every fax transmission.
Print On Error*
Prints a transmission report only when an error occurs.
Print Disable
Does not print a transmission report after a fax transmission.
Print Always*
Prints a transmission report after every fax transmission.
Print On Error
Prints a transmission report only when an error occurs.
Print Disable
Does not print a transmission report after a fax transmission to multiple destinations.
Print Disable*
Does not print the protocol monitor report.
Print Always
Prints a protocol monitor report after every fax transmission.
Print On Error
Prints the protocol monitor report only when an error occurs.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Mode1

5min*
Specifies the time for transition to Power Saver Mode 1 and Power Saver Mode 2 in minutes.


5-60min
Mode2
6min*
1-6min