System information

Alignment and Troubleshooting
4-40
Depth 1 Depth 2 Depth 3 Depth 4
Machine Test Fuser Offset
StandBy Temp. [-20-0]:0*,-5,-10,-15,-20
Run Temp. [-20-0]:0*,-5,-10,-15,-20
101-185mm Temp. [-20-0]:0*,-5,-10,-15,-20
186-216mm Temp. [-20-0]:0*,-5,-10,-15,-20
90 gms Temp. [-20-0]:0*,-5,-10,-15,-20
Bond Temp. [-20-0]:0*,-5,-10,-15,-20
OHP Temp. [-20-0]:0*,-5,-10,-15,-20
Cardstock Temp. [-20-0]:0*,-5,-10,-15,-20
Env. Temp. [-20-0]:0*,-5,-10,-15,-20
Label Temp. [-20-0]:0*,-5,-10,-15,-20
Report
All Report
Protocol
Configuration
Supplies Info
Error Info
Usage Page
ComponentCheck
Service Support
■ Data Setup
SEND LEVEL
You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm.
Caution :
DIAL MODE
This function can choose dial method.
*Default : Dial(Dial/Pulse)
MODEM SPEED
You can set the maximum modem speed.
Communication is done with modem speed automatically set at lower speed when communicating with a
slower speed modem since communication is done on the standard of the side where modem speed is low
for transmission/reception. It is best set 33.6Kbps as default setting.
ERROR RATE
When the error rate is about exceed the set value, the Baud rate automatically adjusts to 2400 bps.
This ensures that the error rate remains below the set value.
You can select the rate between 5% and 10%.
The Send Fax Level is set at the best condition in the shipment from factory.
Never change settings
arbitrarily.