User Guide
Table Of Contents
- Features of your new laser printer
- Safety information
- Contents
- Introduction
- Getting started
- Loading originals and print media
- Copying
- Scanning
- Basic printing
- Faxing
- Sending a fax
- Receiving a fax
- Selecting the paper tray
- Changing receiving modes
- Receiving automatically in Fax mode
- Receiving manually in Tel mode
- Receiving manually using an extension telephone
- Receiving automatically in Ans/Fax mode
- Receiving faxes using DRPD mode
- Receiving in secure receiving mode
- Activating secure receiving mode
- Receiving faxes in memory
- Other ways to fax
- Fax setup
- Using USB flash memory
- Maintenance
- Troubleshooting
- Ordering supplies and accessories
- Installing accessories
- Specifications
- Appendix
- Glossary
- Index
- Software section
- Software section Contents
- Installing Printer Software in Windows
- Basic Printing
- Advanced Printing
- Using Windows PostScript Driver
- Sharing the Printer Locally
- Scanning
- Using other software
- Using Your Printer in Linux
- Using Your Printer with a Macintosh
- Software section Index
Troubleshooting | 67
In the fuser unit area
If paper is jammed in the fuser unit area, follow the next steps to release the
jammed paper.
1. Open the scan unit.
2. Open the inner cover using the handle.
3. Open the inner cover using the handle on it and carefully take the
jammed paper out of the printer.
4. Pull up the paper jam lever to loose the fusing part of the fuser unit and
carefully take the jammed paper out of the printer.
5. Press down the paper jam lever to fasten the fusing part.
6. Close the inner cover.
7. Lowering down the scan unit gently and slowly until it is completely
closed. Ensure that it is securely latched.
Be careful not to pinch your fingers!
Do not touch the fuser inside the inner cover. It is hot and could
cause burns! The fuser's operating temperature is 180
°
C (356
°
F).
Take care when removing paper from the printer.
If the scan unit is not completely closed, the printer will not
operate.