User manual

Installation: Dell 2300MP Projector
file:///C|/Venkat%20Shared/Projectors/2300MP/EN/install.htm[11/30/2012 2:18:55 PM]
Changing the Lamp
Replace the lamp when you see " Lamp is approaching the end of its useful life in
full power operation. Replacement suggested!" message on the screen by carefully
following these instructions. If this problem persists, contact Dell
.
CAUTION: The lamp becomes very hot with in use. Do not attempt to replace the lamp after use until the
projector has been allowed to cool down for at least 30 minutes.
Lamp Changing Procedure:
1. Turn off the projector and disconnect the
power cord.
2. Let the projector cool for at least 30
minutes.
3. Loosen the 2 screws that secure the lamp
cover, and remove the cover.
4. Loosen the 2 screws that secure the lamp.
5. Pull up the lamp by its metal handle.
6. Reverse steps 1 through 5 to install the
new lamp.
7. Reset the lamp by usage time selecting the
left Lamp Reset icon in the OSD
Management
tab.
NOTE: Dell may require that lamps replaced
under warranty be returned to Dell. Otherwise,
contact your local waste disposal agency for the
address of the nearest deposit site.
NOTE: The lamp contains mercury. Disposal
of this material may be regulated due to
environmental considerations. For disposal or
recycling information, please contact your local
authorities or the Electronic Industries Alliance:
www.eiae.org.
CAUTION: Do not touch the bulb or the lamp glass at any time. The bulb may explode due to improper
handling, including the touching of the bulb or the lamp glass.
Back to Contents Page