Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Operating the monitor
- Turning on the monitor
- Using the joystick control
- Using the rear-panel controls
- Using the On-Screen Display (OSD) menu
- Locking the rear-panel control buttons
- Setting the maximum resolution
- Setting the maximum frame rate
- Using the tilt and vertical extension
- Adjusting the rotation display settings of your system
- Troubleshooting
- Appendix
22 │ About your monitor
Plug and Play capability
You can connect the monitor to any Plug and Play-compatible system. The monitor
automatically provides the computer system with its Extended Display Identification
Data (EDID) using Display Data Channel (DDC) protocols so that the system can
configure itself and optimize the monitor settings. Most monitor installations are
automatic; you can select different settings if desired. For more information about
changing the monitor settings, see Operating the monitor.
Universal Serial Bus (USB) interface
This section gives you information about the USB ports that are available on the
monitor.
NOTE: This monitor is SuperSpeed USB 5 Gbps (USB 3.2 Gen1)
compatible.
Transfer speed Data rate Power consumption*
Super-Speed 5 Gbps 4.50 W (Max, each port)
High speed 480 Mbps 4.50 W (Max, each port)
Full speed 12 Mbps 4.50 W (Max, each port)
*Up to 2 A on USB downstream port (with
battery icon) with battery
charging version-compliant devices or normal USB devices.
USB 3.2 Gen1 (5 Gbps) upstream connector
Pin
number
9-pin side of the
connector
1 VCC
2 D-
3 D+
4 GND