Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Operating the monitor
- Turning on the monitor
- Using the joystick control
- Using the rear-panel controls
- Using the On-Screen Display (OSD) menu
- Locking the rear-panel control buttons
- Setting the maximum resolution
- Setting the maximum frame rate
- Using the tilt and vertical extension
- Adjusting the rotation display settings of your system
- Troubleshooting
- Appendix
50 │ Operating the monitor
When you change the default USB settings for the first time, the following message
appears:
NOTE: If you select Yes, the message will not appear the next time you
change the USB settings. When you perform a factory reset, the
message will appear again.
You will see the following message before the DDC
/CI function is disabled:
When the monitor goes into Standby mode, the following message appears:
Activate the computer and wake up the monitor to gain access to the OSD.
NOTE: The message may slightly differ, depending on the connected
input signal.