Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Operating the monitor
- Turning on the monitor
- Using the joystick control
- Using the rear-panel controls
- Using the On-Screen Display (OSD) menu
- Locking the rear-panel control buttons
- Setting the maximum resolution
- Setting the maximum frame rate
- Using the tilt and vertical extension
- Adjusting the rotation display settings of your system
- Troubleshooting
- Appendix
Tro u b l e shoo tin g │ 59
Built-in diagnostics
Your monitor has a built-in diagnostic tool that helps you determine if the screen
abnormality you are experiencing is an inherent problem with your monitor, or with
your computer and video card.
To run the built-in diagnostics:
1. Ensur
e that the screen is clean (no dust particles on the surface of the
screen).
2. Pr
ess and hold Button 5 for four seconds until a menu appears on the screen.
3. Using
the joystick control, highlight the Diagnostics option and press the
joystick button to start the diagnostics
. A gray screen is displayed.
4. Obse
rve if the screen has any defects or abnormalities.
5. T
oggle the joystick once again until a red screen is displayed.
6. Obse
rve if the screen has any defects or abnormalities.
7. Re
peat steps 5 and 6 until the screen displays green, blue, black, and white
colors. Note any abnormalities or defects.
The test is complete when a text screen is displayed. To exit, toggle the joystick
co
ntrol again.
If you do not detect any screen abnormalities upon using the built-in diagnostic tool,
th
e monitor is functioning properly. Check the video card and computer.