Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Operating the monitor
- Turning on the monitor
- Using the joystick control
- Using the rear-panel controls
- Using the On-Screen Display (OSD) menu
- Locking the rear-panel control buttons
- Setting the maximum resolution
- Setting the maximum frame rate
- Using the tilt and vertical extension
- Adjusting the rotation display settings of your system
- Troubleshooting
- Appendix
About your monitor │ 13
5 Stand lock feature Lock the stand to the monitor using a M3 x
6 mm screw (screw not included).
6 DisplayPort Connect to your computer with the DisplayPort
cab
le (shipped with your monitor).
7 SuperSpeed USB
5 Gbps (USB 3.2
Gen
1) Type-B
upstream port
Connect the USB cable (shipped with your
m
onitor) from this port to your computer to
enable the USB ports on your monitor.
8 SuperSpeed USB
5 Gbps (USB 3.2
Ge
n1) Type-A
downstream port (3)
Connect your USB 3.2 Gen1 (5 Gbps) device.*
NOTE: T
o use these ports, you must connect
the USB cable (shipped with your monitor) to
the USB-upstream port on the monitor and to
your computer.
9 Downlights When the monitor setup is complete, tap the
t
ouch sensor at the bottom of the display to
turn the downlights on or off. The factory
setting is on, so the downlights are active if the
power cable is connected (see Downlight).
NOTE: On monitors that are manufactured
from August 2021, the downlights can be
turned on or off only using the OSD menu.
10 SuperSpeed USB
5 Gbps (USB 3.2
Ge
n1) Type-A
downstream port with
Power Charging
Connect to your computer to charge your USB
de
vice.