Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Operating the monitor
- Turning on the monitor
- Using the joystick control
- Using the rear-panel controls
- Using the On-Screen Display (OSD) menu
- Locking the rear-panel control buttons
- Setting the maximum resolution
- Setting the maximum frame rate
- Using the tilt and vertical extension
- Adjusting the rotation display settings of your system
- Troubleshooting
- Appendix
Operating the monitor │ 49
OSD warning message
When the monitor does not support a particular
resolution mode, you will see the
following message:
This means that the monitor cannot synchronize with the signal that it is receiving
from the computer. See Monitor specifications for the Horizontal and Vertical
frequency ranges addressable by this monitor.
The recommended mode is 1920 x
1080.
NOTE: The message may slightly differ, depending on the connected
input signal.
When you adjust the Br
ightness level above the default level for the first time, the
following message appears:
NOTE: If you select Yes, the message will not appear the next time you
change the Brightness settings.
Factory Reset Restores all preset values to the factory default
se
ttings.