Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Operating the monitor
- Turning on the monitor
- Using the joystick control
- Using the rear-panel controls
- Using the On-Screen Display (OSD) menu
- Locking the rear-panel control buttons
- Setting the maximum resolution
- Setting the maximum frame rate
- Using the tilt and vertical extension
- Adjusting the rotation display settings of your system
- Troubleshooting
- Appendix
Operating the monitor │ 51
The OSD functions only in the normal operation mode. If you press any button other
than the power button during the Standby mode, the following message will appear
depending on the selected input:
NOTE: The message may slightly differ, depending on the connected
input signal.
If either HDMI or DP input is selected and
the corresponding cable is not connected,
a floating dialog box as shown below appears.
NOTE: The message may slightly differ, depending on the connected
input signal.
When F
actory Reset is selected, the following message appears:
See Trou b l es hooti ng for more information.