Users Guide
Table Of Contents
- Safety instructions
- About your monitor
- Setting up the monitor
- Connecting the stand
- Using the tilt, swivel, and vertical extension
- Rotating the Display (C2422HE/C2722DE only)
- Configuring the display settings on your computer after rotation (C2422HE/C2722DE only)
- Operating the monitor webcam
- Connecting your monitor
- Dell Power Button Sync (DPBS)
- Organizing your cables
- Securing your monitor using Kensington lock (optional)
- Removing the monitor stand
- Wall mounting (Optional)
- Operating the monitor
- Troubleshooting
- Appendix
52 | Setting up the monitor
Connecting the monitor for DPBS for the first time
Initial monitor power state(OFF)
Initial system power state(OFF)
USB-C
USB-C
For the first time setting up the DPBS function:
1. Make sure both the PC and monitor is OFF.
2. Press the monitor power button to turn ON the monitor.
3. Connect the USB-C cable from the PC to the monitor.
4. Both the monitor and PC will turn ON normally except Dell Optiplex 7090/3090
Ultra platform.
5. When you connect the Dell Optiplex 7090/3090 Ultra platform, you may see both
the monitor and PC will turn ON momentarily. Wait for a while (approximately 6
seconds) and both the PC and monitor will turn OFF. When you press either the
monitor power button or PC power button, both the PC and monitor will turn ON.
The PC system power state is in sync with the monitor power button.
NOTE: You can power the Dell PC* Ultra platform using its DC adaptor
jack. Alternatively, you can power the Dell PC* Ultra platform using
the monitor’s USB-C cable via Power Delivery (PD); please set USB-C
Charging 90 W to On in Off Mode.
* Ensure to check the Dell PC for DPBS supportability.