Owner`s manual

Replacing the Middle Cover | 87
Replacing the Middle Cover
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the middle cover with the screw holes on the
display bezel.
2 Replace the screws that secure the middle cover to the display bezel.
3 Route all the cables through their routing guides on the middle frame.
4 Connect the LVDS and touchscreen cables to the display assembly.
5 Replace the screw that secures the grounding cable to the middle cover.
6 Align the screw holes on the side I/O-board shield with the screw holes on
the display bezel and place the side I/O-board shield on the side-I/O board.
7 Replace the screws that secure the side I/O-board shield to display bezel.
OM_Book.book Page 87 Wednesday, April 3, 2013 1:39 PM