Owner`s manual

Option Description

• Exit - Exits and starts the computer.

Advanced Boot Options The Enable Legacy Option ROMs option will allow the legacy option ROMs to load,

when in UEFI boot mode. Without this option, only UEFI option ROMs will load. This

option is required for Legacy boot mode. This Legacy boot mode is not allowed when

you enable the Secure Boot. By default, the Enable Legacy Option ROMs check-box is

not selected. The other options are:

• Load Defaults - Restores the default settings of the computer.

• Apply - Enables you to apply the settings.

• Exit - Exits and starts the computer.

Date/Time Allows you to set the date and time. The changes to the system date and time takes

effect immediately.

Table 3. System Configuration

Option Description

Integrated NIC Allows you to enable or disable the integrated network card. You can set the

integrated NIC to:

• Disabled

• Enabled

• Enabled w/PXE (This option is selected by default)

• Enabled w/ImageServer

• Enable UEFI Network Stack

NOTE: Depending on the computer and its installed devices, the items listed in

this section may or may not appear.

Serial Port Allows you to define the serial port settings. You can set the serial port to:

• Disabled

• COM1 (This option is selected by default)

• COM2

• COM3

• COM4

NOTE: The operating system may allocate resources even though the setting is

disabled.

SATA Operation Allows you to configure the operating mode of the integrated SATA hard drive

controller.

• Disabled - The SATA controllers are hidden.

• ATA - SATA is configured for ATA mode.

• AHCI - SATA is configured for AHCI mode. This option is enabled by default.

Drives Allows you to enable or disable the various on-board drives:

• SATA-0

• SATA-1