User Manual
Table Of Contents
- Dell OptiPlex 3020–Small Form Factor Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- System Overview
- Removing the Cover
- Installing the Cover
- Removing the Front Bezel
- Installing the Front Bezel
- Removing The Expansion Card
- Installing The Expansion Card
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Drive Cage
- Installing the Drive Cage
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Speaker
- Installing the Speaker
- Memory Module Guidelines
- Removing the Memory
- Installing the Memory
- Removing the System Fan
- Installing the System Fan
- Removing the Power Switch
- Installing the Power Switch
- Removing the I/O Panel
- Installing the I/O Panel
- Removing the Power Supply
- Installing the Power Supply
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Heatsink Assembly
- Installing the Heatsink Assembly
- Removing the Processor
- Installing the Processor
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- System Board Components
- Removing the System Board
- Installing the System Board
- System Setup
- Diagnostics
- Troubleshooting Your Computer
- Technical Specifications
- Contacting Dell
3. Lift the cover upward to a 45–degree angle and remove it from the computer.
Installing the Cover
1. Place the cover on the computer.
2. Slide the computer cover towards the front of the chassis until it is fully engaged.
3. Tighten the thumbscrew in clockwise direction to secure the computer cover.
4. Follow the procedures in
After Working Inside Your Computer
.
11