User Manual
Table Of Contents
- Dell OptiPlex 3020–Small Form Factor Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- System Overview
- Removing the Cover
- Installing the Cover
- Removing the Front Bezel
- Installing the Front Bezel
- Removing The Expansion Card
- Installing The Expansion Card
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Drive Cage
- Installing the Drive Cage
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Speaker
- Installing the Speaker
- Memory Module Guidelines
- Removing the Memory
- Installing the Memory
- Removing the System Fan
- Installing the System Fan
- Removing the Power Switch
- Installing the Power Switch
- Removing the I/O Panel
- Installing the I/O Panel
- Removing the Power Supply
- Installing the Power Supply
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Heatsink Assembly
- Installing the Heatsink Assembly
- Removing the Processor
- Installing the Processor
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- System Board Components
- Removing the System Board
- Installing the System Board
- System Setup
- Diagnostics
- Troubleshooting Your Computer
- Technical Specifications
- Contacting Dell
Installing the System Board
1. Align the system board to the port connectors on the rear of the chassis and place the system
board in the chassis.
2. Tighten the screws securing the system board to the chassis.
3. Connect the cables to the system board.
4. Install the:
a) power supply
b) expansion card(s)
c) heat sink assembly
d) memory
e) drive cage
f) optical drive
g) front bezel
h) cover
5. Follow the procedures in
After Working Inside Your Computer
.
34