Users Guide

34 │ Setting up the monitor
Setting up the monitor
Connecting the stand
NOTE: The stand is detached when the monitor is shipped from the
factory.
NOTE: The following procedure is applicable for the stand that shipped
with your monitor. If you are connecting a third-party stand, see the
documentation that shipped with the stand.
To attach the monitor stand:
1.
Follow the instructions on the flaps of carton to remove the stand from the
top cushion that secures it.
2.
Connect the stand base to the stand riser.
3.
Open the screw handle on the stand base and tighten the screw to secure the
stand riser to the stand base.
4.
Close the screw handle.
3
2
1
4
5.
Slide the tabs on the stand assembly into the slots on the monitor and press
the stand assembly down to snap it into place.