User`s guide
Table Of Contents
- 1 Your Dell Projector 7
- 2 Connecting Your Projector 10
- 3 Using Your Projector 24
- 4 Troubleshooting Your Projector 101
- 5 Specifications 108
- 6 Contacting Dell 115
- 7 Appendix: Glossary 116
- Your Dell Projector
- Connecting Your Projector
- Using Your Projector
- Turning Your Projector On
- Turning Your Projector Off
- Adjusting the Projected Image
- Adjusting the Projector Zoom and Focus
- Adjusting Projection Image Size
- Using the Control Panel
- Using the Remote Control
- Installing the Remote Control Batteries
- Operating Range With Remote Control
- Using the On-Screen Display
- Wireless Networking Installation
- Presentation to Go (PtG) Installation
- Audio Projection Installation
- Video Stream Installation
- Managing the Projector From Web Management
- Make Application Token
- Troubleshooting Your Projector
- Specifications
- Contacting Dell
- Appendix: Glossary
34 Using Your Projector
5 Laser Point the remote control at the screen, press and
hold the laser button to activate the laser light.
WARNING: Do not look at the laser point
when it is active. Avoid directing the laser
light on your eyes.
6 Aspect Ratio Press to change the aspect ratio of a displayed
image.
7 Keystone adjustment Press to adjust image distortion caused by tilting
the projector (+40/-35 degrees).
8
Page up
Press to move to the previous page.
NOTE: The Mini USB cable must be
connected if you want to use the Page Up
feature.
9
Page down
Press to move to the next page.
NOTE: The Mini USB cable must be
connected if you want to use the Page Down
feature.
10
Keystone adjustment
Press to adjust image distortion caused by tilting
the projector (+40/-35 degrees).
11 S-Video Press to choose S-Video source.
12 Video Press to choose Composite Video source.
13 Video mode The projector has preset configurations that are
optimized for displaying data (presentation
slides) or video (movies, games, etc.).
Press the Video Mode button to toggle between
Presentation mode, Bright mode, Movie mode,
sRGB, or Custom mode.
Pressing the Video Mode button once will show
the current display mode. Pressing the Video
Mode button again will switch between modes.
14 Blank screen Press to hide/unhide the image.
15
Up
Press to navigate through the On-Screen Display
(OSD) Menu items.