User Manual

Back to Contents Page
The default IP port is 06910.
Client DHCP
Specifies how the client obtains the IP address.
l Static IP
l DHCP (default)
Client IP
Specifies the static IP address of the client.
The default IP address is 255.255.255.255
NOTE: To set Client IP you must set Client DHCP to Static IP
Client SubnetMask
Specifies the subnet mask for the client.
The default setting is 255.255.255.255
NOTE: To set Client SubnetMask you must set Client DHCP to Static IP
Client Gateway
Specifies the gateway IP address for the client.
The default setting is 255.255.255.255
NOTE: To set Client SubnetMask you must set Client DHCP to Static IP
License Status
Displays the current license status.
Post Behavior
Fast Boot
When enabled (default), your computer starts more quickly because it skips certain configurations and tests.
NumLock LED
Enables or disables the NumLock feature when your computer starts.
When enabled (default), this option activates the numeric and mathematical features shown at the top of each key. When disabled, this option
activates the cursor-control functions labeled on the bottom of each key
POST
Hotkeys
Allows you to specify the function keys to display on the screen when the computer starts.
l Enable F2 = Setup (enabled by default)
l Enable F12 = Boot menu (enabled by default)
Keyboard
Errors
Enables or disables keyboard error reporting when the computer starts.
This option is enabled by default.
MEBx Hotkey
sign-on displays a message stating the keystroke sequence required to enter the Manageability Engine BIOS Extensions(MEBx) Setup program.
This option is enabled by default.
OS Install
Set the system maximum memory for OS to load while installation. If enabled the maximum available memory is 256MB RAM.
This option is disable by default.
Reason being some operating system will not complete install with more then 2GB of system memory.
System Logs
BIOS Events
Displays the system event log and allows you to:
l Clear Log
l Mark all Entries