User Guide
Table Of Contents
- Dell Vostro 2520 Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- Recommended Tools
- Removing the Battery
- Installing the Battery
- Removing the Secure Digital (SD) Card
- Installing the Secure Digital (SD) Card
- Removing the Hinge Cover
- Installing the Hinge Cover
- Removing the Keyboard
- Installing the Keyboard
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Memory Module
- Installing the Memory Module
- Removing the Palmrest
- Installing the Palmrest
- Removing the Power-Button Board
- Installing the Power-Button Board
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the Wireless Local Area Network (WLAN) Card
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the USB Board
- Installing the USB Board
- Removing the Microphone
- Installing the Microphone
- Removing the Heat-Sink Fan Assembly
- Installing the Heat-Sink Fan Assembly
- Removing the Processor
- Installing the Processor
- Removing the System Board
- Installing the System Board
- Removing the Speakers
- Installing the Speakers
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the Power-Connector Port and Bracket
- Installing the Power-Connector Port and Bracket
- Removing the Display Bezel
- Installing the Display Bezel
- Removing the Camera
- Installing the Camera
- Removing the Display Panel
- Installing the Display Panel
- Removing the Low-Voltage Differential Signaling (LVDS) Cable
- Installing the Low-Voltage Differential Signaling (LVDS) Cable
- System Setup
- Diagnostics
- Technical Specifications
- Contacting Dell
Installing the Optical Drive
1. Slide the optical drive into the compartment on the left side of the chassis.
2. Tighten the screw to secure the optical drive to the computer.
3. Install the keyboard.
4. Install the battery.
5. Follow the procedures in
After Working Inside Your Computer
.
Removing the Memory Module
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the battery.
3. Remove the keyboard.
4. Pry the retention clips away from the memory module until it pops up.
5. Remove the memory module from the computer.
14