User Manual
Table Of Contents
- Dell EMC PowerEdge T40 Installation and Service Manual
- Contents
- About this document
- PowerEdge T40 system overview
- Initial system setup and configuration
- Pre-operating system management applications
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Front bezel
- Hard drives
- PSU assembly
- Power supply unit
- Expansion cards
- Memory module
- System battery
- Optical drive
- Speaker
- System fan
- Intrusion switch
- Processor and heatsink
- System board
- Control panel
- Power button module
- Jumpers and connectors
- Technical specifications
- Chassis dimensions
- System weight
- Processor specifications
- Supported operating systems
- PSU specifications
- System fan specifications
- System battery specifications
- Expansion card specifications
- Memory specifications
- Storage controller specifications
- Drive specifications
- Ports and connectors specifications
- Video specifications
- Environmental specifications
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Before working inside your system
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Power off the system and attached peripherals.
2. Disconnect the system from the electrical outlet, and disconnect the peripherals.
3. Remove the system cover
4. Lay the system on its side.
After working inside your system
Prerequisites
Follow the safety guidelines listed in Safety instructions on page 33.
Steps
1. Install the system cover.
2. Place the system upright on a flat, stable surface.
3. Reconnect the peripherals and connect the system to the electrical outlet.
4. Power on the attached peripherals and then power on the system.
Recommended tools
You need the following tools to perform the removal and installation procedures:
● Phillips #1 screwdriver
● Phillips #2 screwdriver
● Torx #T15 screwdriver
● 5mm hex nut screwdriver
● Plastic scribe
● Wrist grounding strap connected to the ground
● ESD mat
System cover
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Pull the system cover release latch.
2. Remove the system cover.
34
Installing and removing system components