User Manual
Table Of Contents
- Dell EMC PowerEdge T40 Installation and Service Manual
- Contents
- About this document
- PowerEdge T40 system overview
- Initial system setup and configuration
- Pre-operating system management applications
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Front bezel
- Hard drives
- PSU assembly
- Power supply unit
- Expansion cards
- Memory module
- System battery
- Optical drive
- Speaker
- System fan
- Intrusion switch
- Processor and heatsink
- System board
- Control panel
- Power button module
- Jumpers and connectors
- Technical specifications
- Chassis dimensions
- System weight
- Processor specifications
- Supported operating systems
- PSU specifications
- System fan specifications
- System battery specifications
- Expansion card specifications
- Memory specifications
- Storage controller specifications
- Drive specifications
- Ports and connectors specifications
- Video specifications
- Environmental specifications
- System diagnostics and indicator codes
- Getting help
- Documentation resources
a. Memory modules.
b. Processor.
c. Heat sink module.
d. Expansion card, if installed
2. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured by using the cable
securing bracket.
3. Close the PSU assembly.
4. Follow the procedure listed in After working inside your system.
5. Let the system boot.
6. Ensure that you:
a. Update the BIOS firmware.
b. Enter the system service tag after you install the system board. For more information see Entering the service Tag.
Entering the System Service Tag by using the Service Menu
Prerequisites
WARNING: Service Menu only appears once after a new system board is replaced. The setting in Service Menu
cannot be undone once you apply the changes.
NOTE: Intel Active Management Technology (AMT) is supported only on Intel Xeon processor-based systems.
NOTE: Intel Pentium/Core processor-based systems support Intel Standard Manageability.
This procedure is used to update the service tag after a system board replacement.
Steps
1. Remove the system cover.
a. On the inside of the system cover near the System Information Label, note down the number on the AMT/VPRO QR
code label.
2. Install the system cover.
3. Start the system.
NOTE: If the system is powered on, shut the system down and start it up (cold boot).
4. After the system has started up, the Service Menu screen is displayed.
5. Select the number in AMT Options box corresponding to the AMT/VPRO number noted earlier from the system cover.
NOTE:
MANAGEABILITY ENGINE (ME) DISABLED and MANAGEABILITY ENGINE (ME) LOCKOUT are not supported
on the PowerEdge T40.
6. Type the service tag information in the Enter Service Tag section.
7. Type the optional asset tag information in the Enter Asset Tag section.
8. Click OK to save the changes and exit.
Entering the system Service Tag by using System Setup
Steps
1. Turn on the system.
2. Press F2 to enter System Setup.
3. Click Service Tag Settings.
4. Enter the Service Tag.
NOTE:
You can enter the Service Tag only when the Service Tag field is empty. Ensure that you enter the correct
Service Tag. After the Service Tag is entered, it cannot be updated or changed.
72 Installing and removing system components