User Manual
Table Of Contents
- Dell EMC PowerEdge T40 Installation and Service Manual
- Contents
- About this document
- PowerEdge T40 system overview
- Initial system setup and configuration
- Pre-operating system management applications
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Front bezel
- Hard drives
- PSU assembly
- Power supply unit
- Expansion cards
- Memory module
- System battery
- Optical drive
- Speaker
- System fan
- Intrusion switch
- Processor and heatsink
- System board
- Control panel
- Power button module
- Jumpers and connectors
- Technical specifications
- Chassis dimensions
- System weight
- Processor specifications
- Supported operating systems
- PSU specifications
- System fan specifications
- System battery specifications
- Expansion card specifications
- Memory specifications
- Storage controller specifications
- Drive specifications
- Ports and connectors specifications
- Video specifications
- Environmental specifications
- System diagnostics and indicator codes
- Getting help
- Documentation resources
Drive specifications
Drives
The PowerEdge T40 system supports the following drive configurations:
Table 28. Drive configurations
Configuration Capacity
Up to 3 x 3.5-inch drive cabled SATA drives. 1 / 2 / 4 TB
NOTE: The PowerEdge T40 system only supports entry drives.
Entry Drives : Least expensive drives used in applications where low usage and limited total number of drives are applicable.
Due to restrictions on use, these drives are available in a small number of systems and configurations.
Optical drives
The PowerEdge T40 system supports the following optical drives.
Table 29. Supported optical drive type
Supported drive type Supported number of drives
Slim 9.5 mm SATA DVD+/-RW drive One
NOTE: External optical drives can be connected through the USB ports.
Ports and connectors specifications
USB ports specifications
The PowerEdge T40 system supports the USB ports mentioned below:
Table 30. PowerEdge T40 system USB specifications
Front Panel Rear Panel
● Two USB 2.0-compliant Type-A ports
● One USB 3.0 Type-A compliant port
● One USB 3.1-compliant Type-C port
● Four USB 3.0 Type-A compliant ports
● Two USB 2.0 Type-A compliant ports
NIC port specifications
The PowerEdge T40 system supports a Network Interface Controller (NIC) port on the back panel, which is available in
10/100/1000 Mbps NIC configurations.
Serial connector specifications
The PowerEdge T40 system supports one serial connector on the back panel, which is a 9-pin connector, Data Terminal
Equipment (DTE), 16550-compliant.
84
Technical specifications