User Manual
Table Of Contents
- Dell EMC PowerEdge T40 Installation and Service Manual
- Contents
- About this document
- PowerEdge T40 system overview
- Initial system setup and configuration
- Pre-operating system management applications
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Front bezel
- Hard drives
- PSU assembly
- Power supply unit
- Expansion cards
- Memory module
- System battery
- Optical drive
- Speaker
- System fan
- Intrusion switch
- Processor and heatsink
- System board
- Control panel
- Power button module
- Jumpers and connectors
- Technical specifications
- Chassis dimensions
- System weight
- Processor specifications
- Supported operating systems
- PSU specifications
- System fan specifications
- System battery specifications
- Expansion card specifications
- Memory specifications
- Storage controller specifications
- Drive specifications
- Ports and connectors specifications
- Video specifications
- Environmental specifications
- System diagnostics and indicator codes
- Getting help
- Documentation resources
NIC indicator codes
Each NIC on the back panel has an indicator that provides information about the network activity and link status. The activity
LED indicates whether the NIC is currently connected or not. The link LED indicates the speed of the connected network.
Figure 58. NIC indicators
1. link indicator
2. activity indicator
Table 41. NIC indicators
Convention Status Condition
A Link and activity indicators are off The NIC is not connected to the network.
B Link indicator is green The NIC is connected to a valid network at 10 Mbps or
100 Mbps port speed.
C Link indicator is orange The NIC is connected to a valid network at 1000 Mbps
port speed.
D Activity indicator is flashing yellow Network data is being sent or received.
Power supply unit Built-in Self Test
PowerEdge T40 supports a power supply unit Built-in Self Test (BIST).
Steps
1. Turn off your server.
2. Disconnect the power cord from the power supply unit, and wait for 15 seconds.
3. After 15 seconds, connect the power cord back to the PSU
4. Press the PSU BIST button.
● If the LED turns on and remains on while the BIST button is pressed, it indicates that the power supply unit is functional.
Continue with troubleshooting steps for other devices.
● If the LED does not turn on, it indicates PSU failure.
System diagnostics and indicator codes
89