User Manual

Hardware Installation 15

Tighten the bracket screw, if any, or use the system’s retention clips to

secure the controller to the system’s chassis.

For the

Internal Tape Adapter

card, connect the cables from the end

devices to the controller. See Figure 3-2.

NOTE: Although the Internal Tape Adapter has two internal connectors, only one

internal tape device is supported. Use the connector (on the card) labeled 'A'.

Figure 3-2. Connecting the Cable for the Internal Tape Adapter

For the 6 Gbps SAS HBA controller, connect the cable from the external

tape device or enclosure to the adapter. See Figure 3-3.

NOTE: The external cable can be connected to either of the two

external connectors.

1 cable 2 SAS x4 internal connector

3 Internal Tape Adapter