User Manual

Troubleshooting 31
BIOS Error Messages
• Message : Press <Ctrl+C> to enable BIOS
Description : When the BIOS is disabled, you are given the option to
enable it by entering the
Configuration Utility . You can change the setting
to
Enabled in the Configuration Utility .
•
Message : Adapter configuration may have changed,
reconfiguration is recommended!
Press CTRL-C to run Dell 6 Gbps SAS HBA
Configuration
Utility
…
Description : Start the Configuration Utility and confirm the
configuration of the 6 Gbps SAS HBA or Internal Tape Adapter controller.
•
Message : Initializing...
Description : This message is displayed while the BIOS is waiting to
initialize.
• Message : SAS discovery error
Description : Indicates that there is a discovery error reported by the
firmware and may be accompanied by more such messages. Enter the
Configuration Utility to investigate
.
•
Message : Device not available at HBA n, HDL n, LUN
Description : Device may not be ready at this time. The device will be
retried. If the problem persists, restart your system.
• Message : ERROR! Device is not responding to Read
Capacity
Description : The device does not respond to a read capacity command.
Contact Dell.
• Message : Failed to add device, too many devices!
Description : Cannot allocate resources for additional devices.
•
Message : ERROR! Adapter Malfunctioning!
Description : The adapter did not initialize properly. There may be a
problem with the adapter configuration. Reload the BIOS configuration.
Start the
Configuration Utility again and see if the issue persists.