Service Manual
Table Of Contents
- XPS 13 Plus 9320 / XPS 9320 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- System diagnostic lights
- SupportAssist diagnostics
- Built-in self-test (BIST)
- Recovering the operating system
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Backup media and recovery options
- Real Time Clock—RTC reset
- Getting help and contacting Dell
6. Connect the keyboard cable and close the latch of the keyboard connector.
Next steps
1. Install the power button with fingerprint reader.
2. Install the system board.
NOTE: The system board can be replaced with the following components attached:
● heat sink
● fans
● solid-state drive
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Palm-rest assembly
Removing the palm-rest assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the system board.
NOTE:
The system board can be removed with the following components attached:
● heat sink
● fans
● solid-state drive
5. Remove the power button with fingerprint reader.
6. Remove the keyboard.
About this task
The following image(s) indicate the location of the palm-rest assembly and provides a visual representation of the removal
procedure.
44
Removing and installing components