Service Manual
Table Of Contents
- OptiPlex 5000 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 5000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Hard-drive and optical-drive bracket
- Optical drive
- Solid-state drive
- Hard-drive and optical-drive supporting bracket
- SD-card reader
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Processor fan and heat-sink assembly
- Voltage regulator heat sink
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP/USB Type-C)
- Chassis fan
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
Steps
1. Push the coin-cell battery-release lever on the coin-cell battery socket to release the coin-cell battery out of the socket.
2. Remove the coin-cell battery.
Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the installation
procedure.
44
Removing and installing components