Service Manual
Table Of Contents
- Vostro 15 5510 Service Manual
- Working on your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of your system
- Base cover
- Battery
- Battery cable
- Memory
- Solid-state drive—M.2 slot one
- Solid-state drive—M.2 slot two
- Wireless card
- Fan
- Coin-cell battery
- Heat sink
- Network-port bracket
- I/O board
- Speakers
- Touchpad
- Display assembly
- Power button with optional fingerprint reader
- Power-adapter port
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help
Steps
1. Place the network-port bracket on the I/O board.
2. Align the screw holes on the network-port bracket to the screw holes on the I/O board.
3. Replace the two (M2x5) screws that secure the network-port bracket to the I/O board.
Next steps
1. Install the base cover.
2. Exit Service Mode.
3. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
4. Remove the network-port bracket.
About this task
The following images indicate the location of the I/O board and provide a visual representation of the removal procedure.
42
Removing and installing components