Service Manual
Table Of Contents
- OptiPlex 3000 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 3000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Disk-drive cage
- Optical drive
- Solid-state drive
- Bay-support bracket
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Processor fan and heat-sink assembly
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP)
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
Steps
1. Remove the two (6x32) screws that secure the hard-drive caddy to the hard-drive and optical-drive cage.
2. Slide the hard-drive carrier away from the chassis and lift hard-drive carrier out of the disk-drive cage.
3. Remove the two (6x32) screws that secure the hard drive to the carrier.
4. Slide and remove the hard drive from the carrier.
Installing the 3.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3.5-inch hard drive and provide a visual representation of the installation
procedure.
Removing and installing components
23