Service Manual
Table Of Contents
- OptiPlex 3000 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 3000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Disk-drive cage
- Optical drive
- Solid-state drive
- Bay-support bracket
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Processor fan and heat-sink assembly
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP)
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
Steps
1. Connect the power and SATA cables to the optical drive while holding the disk-drive cage upside down.
2. Hold the disk-drive cage upright and align the mounting points with the ones on the chassis.
3. Push the disk-drive cage until the assembly is secured onto the chassis.
4. Move the lock handle from the locking mechanism towards the right
5. Install the single (6-32) screw to the locking mechanism to lock the disk-drive cage in place.
6. Route the optical drive's power and data cables through the routing guide on the disk-drive cage.
7. Route the hard-drive power and SATA cables through the routing guide on the lock.
Next steps
1. Install the 3.5-inch hard-drive.
2. Install the 2.5-inch hard-drive.
3. Install the front bezel.
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
30
Removing and installing components