Service Manual
Table Of Contents
- OptiPlex 3000 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 3000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Disk-drive cage
- Optical drive
- Solid-state drive
- Bay-support bracket
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Processor fan and heat-sink assembly
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP)
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
Steps
1. Remove the single (M2x3) screw to release the optical drive from the disk-drive cage.
2. Slide the optical drive out of the disk-drive cage.
Installing the optical-drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images show the optical-drive and provide a visual representation of the installation procedure.
Removing and installing components 33