Service Manual
Table Of Contents
- OptiPlex 3000 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 3000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Disk-drive cage
- Optical drive
- Solid-state drive
- Bay-support bracket
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Processor fan and heat-sink assembly
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP)
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
Steps
1. Align the graphics card with the PCIe x16 card slot on the system board.
2. Using the alignment post on the PCIe slot, connect the card in the connector and press down firmly. Ensure that the card is
firmly seated.
3. Close the PCIe door.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Removing the Dell Ultra Speed Drive Gen 4 card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
Removing and installing components
59