Service Manual
Table Of Contents
- OptiPlex 3000 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 3000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Disk-drive cage
- Optical drive
- Solid-state drive
- Bay-support bracket
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Processor fan and heat-sink assembly
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP)
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
8. M.2 WLAN slot
9. Hard-drive data cable (SATA 0)
10. Optical-drive/hard-drive data cable (SATA 1)
11. SATA power cable
12. Internal-speaker cable
13. a. PCIe x16 slot (SLOT 2)
b. PCIe x1 slot (SLOT 1)
14. Coin-cell battery socket
15. Processor socket
16. I/O cable
Removing the system board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard-drive.
5. Remove the 3.5-inch hard-drive.
6. Remove the disk-drive cage.
7. Remove the expansion card.
8. Remove the Optional I/O modules.
9. Remove the solid-state drive.
10. Remove the WLAN card.
11. Remove the heat-sink and fan assembly.
12. Remove the memory modules.
13. Remove the processor.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
Removing and installing components
71