Service Manual
Table Of Contents
- Latitude 5430 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5430
- SIM card tray
- MicroSD card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- Heat sink
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Display assembly
- Display bezel
- Display panel
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display hinges
- Display back cover
- Palm-rest assembly
- Dummy SIM-card slot filler
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
About this task
The following image indicates the location of the 3-cell battery and provides a visual representation of the installation procedure.
NOTE: If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
Steps
1. Align and place the battery from the left side on the computer.
2. Replace the three (M2x5) screws to secure the battery to the palm-rest assembly.
3. Connect the battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Install the microSIM card.
3. Install the microSD card.
4. Follow the procedure in after working inside your computer.
Removing the 4-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD card.
3. Remove the microSIM card.
4. Remove the base cover.
NOTE:
If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
About this task
The following images indicate the location of the battery and provide a visual representation of the removal procedure.
Removing and installing components
31