Service Manual

Figure 2. Removing Infrared camera module
Steps
NOTE:
For models shipped with a camera/microphone, there is a recess near the camera/microphone module, indicated
by an arrow etched on the grounding foil, that should be used to begin the prying process. Starting from the recess at the
bottom edge of the camera/microphone module, pry up the camera/microphone module ensuring that the two tiny pegs
used to secure the camera/microphone module in place is not damaged throughout the prying process.
1. Peel the two conductive tapes that secure the camera module in place.
2. Disconnect the camera module cable from the connector on the camera module.
3. Carefully lift the camera module from the display back cover.
Installing the camera module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the camera module and provides a visual representation of the installation
procedure.
72
Removing and installing components