Service Manual
Table Of Contents
- Latitude 5530 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5530
- Subscriber Identity Module (SIM) card
- Micro Secure Digital (SD) Card
- Base cover
- WLAN card
- WWAN card
- Solid-state drive
- Memory modules
- Battery
- Battery cable
- Assembly inner frame
- LED board
- System fan
- Heat sink
- Removing the heat sink (for computers shipped with integrated graphics card)
- Installing the heat sink (for computers shipped with integrated graphics card)
- Removing the heat sink (for computers shipped with discrete graphics card)
- Installing the heat sink (for computers shipped with discrete graphics card)
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Keyboard bracket
- Display assembly
- Display bezel
- Display panel
- Display hinges
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display back cover
- Dummy SIM-card slot filler
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
1. Loosen the captive screw that secures the WLAN card bracket to the WLAN card.
2. Remove the WLAN card bracket off the WLAN card.
3. Disconnect the antenna cables from the WLAN card.
4. Remove the WLAN card at an angle from the WLAN card slot.
Installing the WLAN card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WLAN card and provides a visual representation of the installation procedure.
Steps
1. Connect the antenna cables to the WLAN card.
The following table provides the antenna-cable color scheme:
Table 2. Antenna-cable color scheme
Connectors on the WLAN card Antenna-cable color
Main (white triangle) White
22 Removing and installing components