Personal Computer User Manual
Table Of Contents
- Dell OptiPlex 9020 AIO Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- System Overview
- Removing the VESA Stand
- Installing the VESA Stand
- Removing the Back Cover
- Installing the Back Cover
- Removing the Memory
- Installing the Memory
- Removing the VESA Mount Bracket
- Installing the VESA Mount Bracket
- Removing the Power and On-Screen Display (OSD) Buttons Board
- Installing the Power and OSD Buttons Board
- Removing the System-Board Shield
- Installing the System-Board Shield
- Removing the Converter Board
- Installing the Converter Board
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the WLAN Card
- Removing the Heat-Sink Assembly
- Installing the Heat-Sink Assembly
- Removing the Processor Fan
- Installing the Processor Fan
- Removing the Power-Supply Fan
- Installing the Power-Supply Fan
- Removing the I/O Board Shield
- Installing the I/O Board Shield
- Removing the Power Supply Unit (PSU)
- Installing the Power Supply Unit
- Removing the Processor
- Installing the Processor
- Removing the Speakers
- Installing the Speakers
- Removing the System Board
- System Board Layout
- Installing the System Board
- Removing the Heat Sink (Graphics Card)
- Installing the Heat Sink (Graphics Card)
- Removing the Antenna Module
- Installing the Antenna Module
- Removing the Display Panel
- Installing the Display Panel
- Removing the Camera
- Installing the Camera
- System Setup
- Technical Specifications
- Contacting Dell
Installing the Optical Drive
1. Place the optical-drive bracket on the optical drive.
2. Tighten the screws that secure the optical-drive bracket to the optical drive.
3. Align and slide the optical drive into its slot.
4. Connect the optical-drive cable.
5. Tighten the screws that secure the optical drive to the computer.
6. Install the:
a) back cover
b) VESA stand
7. Follow the procedures in
After Working Inside Your Computer
.
Removing the Hard Drive
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
3. Unthread the cables from the notches on the hard-drive bracket. Disconnect the hard-drive cables from the hard
drive.
4. Remove the screw that secures the hard-drive bracket to the system board. Slide and lift the hard-drive bracket
away from the computer.
19