Personal Computer User Manual
Table Of Contents
- Dell OptiPlex 9020 AIO Owner's Manual
- Working on Your Computer
- Removing and Installing Components
- System Overview
- Removing the VESA Stand
- Installing the VESA Stand
- Removing the Back Cover
- Installing the Back Cover
- Removing the Memory
- Installing the Memory
- Removing the VESA Mount Bracket
- Installing the VESA Mount Bracket
- Removing the Power and On-Screen Display (OSD) Buttons Board
- Installing the Power and OSD Buttons Board
- Removing the System-Board Shield
- Installing the System-Board Shield
- Removing the Converter Board
- Installing the Converter Board
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the WLAN Card
- Removing the Heat-Sink Assembly
- Installing the Heat-Sink Assembly
- Removing the Processor Fan
- Installing the Processor Fan
- Removing the Power-Supply Fan
- Installing the Power-Supply Fan
- Removing the I/O Board Shield
- Installing the I/O Board Shield
- Removing the Power Supply Unit (PSU)
- Installing the Power Supply Unit
- Removing the Processor
- Installing the Processor
- Removing the Speakers
- Installing the Speakers
- Removing the System Board
- System Board Layout
- Installing the System Board
- Removing the Heat Sink (Graphics Card)
- Installing the Heat Sink (Graphics Card)
- Removing the Antenna Module
- Installing the Antenna Module
- Removing the Display Panel
- Installing the Display Panel
- Removing the Camera
- Installing the Camera
- System Setup
- Technical Specifications
- Contacting Dell
Installing the I/O Board Shield
1. Connect the power-connector cable to the system board.
2. Place the I/O board shield on the computer.
3. Pass the power connector and fix it to the socket. Tighten the screws that secure the I/O board shield to the
chassis.
4. Tighten the screws that secure the power connector to the I/O shield.
5. Place the I/O panel on the computer.
6. Install:
a) power-supply fan
b) system-board shield
c) VESA mount bracket
d) back cover
e) VESA stand
7. Follow the procedures in
After Working Inside Your Computer
.
Removing the Power Supply Unit (PSU)
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
d) system-board shield
e) input/output (I/O) board shield
f) power-supply fan
3. Disconnect the power-supply cables from the system board. Unthread the cable from the hooks in the computer.
28